Like the inner race, the outer race is matched marked

The expansion bearing outer race is flat

IMPORTANT: Fitting of retained bearing outer race and housing

The expansion outer race is fitted to the expansion housing. Observe matched numbers

Like the inner race, the outer race is matched marked

The retained bearing has a lipped outer race

The retained outer race is fitted to a retained housing. Observe matched numbers

The retained housing differs from the expansion housing in that it has pusher rods and side screws. Place pusher rods in holes on side of housing

Push in the pusher rods and fit side screws

Note these side screws should only be tightened after complete assembly of the housing in position

The lower half of the housing may now be fitted to the bearing once the cage assembly has been greased